ULTRA 100 OFFSET AXLE PANHARD BRACKET

ULTRA 100 OFFSET AXLE PANHARD BRACKET

  • $40.00


ULTRA 100 OFFSET AXLE PANHARD BRACKET

OVERLAND PROTOCOL PART#OPB4WK0177

This is our idea of the correct way to make an Offset Panhard / Trackbar bracket, it seems like 3 out of 4 need to be on the leading edge of the axle for clearance issues. The center of the heim will be 6", 7" or 8" vertically from the center of the axle tube and 3.5" forward of the center of the axle tube. They are cut to a 3 1/4" axle tube radius so they can be modified to fit any tube diameter. This bracket is made from 3/16" 100,000 min yield steel plate and bent perfectly so you don't have to play with the grinder to make them fit! You will also notice that the design of this bracket allows you to weld it together with fillet welds instead of butt welds.This is just another way that we designed strength into the bracket. This bracket has two drain holes built in. These are setup for a mounting width of 2" and have 5/8" holes.


We Also Recommend

WIRED WINCH REMOTE

WIRED WINCH REMOTE

Regular price $19.95
CORDED UNIVERSAL GRAB HANDLES

CORDED UNIVERSAL GRAB HANDLES

Regular price $29.95
1-INCH TIE-DOWN STRAP

1-INCH TIE-DOWN STRAP

Regular price $12.95
ARB On-Board Twin High Performance 12 Volt Air Compressor - CKMTA12

ARB On-Board Twin High Performance 12 Volt Air Compressor - CKMTA12

Regular price $575.00
Twin Air Compressor Kit

Twin Air Compressor Kit

Regular price $925.00