OFFSET AXLE PANHARD BRACKET 1/4"

  • $34.00


OFFSET AXLE PANHARD BRACKET 1/4"

Part Number: OPB4WK1050

This is our idea of the correct way to make an Offset Panhard / Trackbar bracket, it seems like 3 out of 4 need to be on the leading edge of the axle for clearance issues. The center of the heim will be 6", 7" or 8" vertically from the center of the axle tube and 3.5" forward of the center of the axle tube. They are cut to fit a 3" axle tube so they can be modified to fit any tube diameter, fabricated from 1/4" plate, and bent perfectly so you don't have to play with the grinder to make them fit! They have two drain holes built in. These are setup for a 2" ID and have 5/8 inch bolt holes so just about any heim will fit with minimal misalignment.


We Also Recommend

WIRED WINCH REMOTE

WIRED WINCH REMOTE

Regular price $19.95
CORDED UNIVERSAL GRAB HANDLES

CORDED UNIVERSAL GRAB HANDLES

Regular price $29.95
1-INCH TIE-DOWN STRAP

1-INCH TIE-DOWN STRAP

Regular price $12.95
ARB On-Board Twin High Performance 12 Volt Air Compressor - CKMTA12

ARB On-Board Twin High Performance 12 Volt Air Compressor - CKMTA12

Regular price $575.00
Twin Air Compressor Kit

Twin Air Compressor Kit

Regular price $925.00