Ford Rear Dana 60 Disc Brackets, '76 & Older


Ford Rear Dana 60 Disc Brackets, '76 & Older

Part Number: OPFORD60OLD
Requires single steel wheel 15" with a maximum 4" back spacing
 
Here you are, an easy bolt on bracket for the Pre '77 Ford full float D60 axles! This one also uses the GM Caliper ('73-87 3/4 Ton 4x4 Front) because it is 1/2 the cost of the Ford and way less expensive to put together than the wedge system. The rotor is a 73-87 Chevy 3/4 4x4 Ton Front rotor. These were a long time coming but way worth the wait! These are only for the Ford D60, if someone tells you they are the same hang up the phone, these are for the early Ford D60, the ones with slip on drums. Remember that distinction because there are 3: Ford, GM &  Dodge are all different! All of our brake brackets are sold in pairs.



*NOTE* Double check your wheel stud diameter and length. The rotors recommended for this kit are for a 5/8" knurled diameter stud so you will need to drill the rotors if your studs are larger or try Dormin wheel stud #610-180 which has a 5/8" knurled diameter for the rotor/hub and a 9/16 diameter lug nut. Be sure you have a minimum of 5/8" lug nut thread engagement when torquing wheels 

NAPA Part numbers for '73-'87 3/4 Ton Front, 4x4, Chevy Calipers and Rotors: 

Caliper ONLY: LH - N4674, RH - N4673 - Both of these are LATER year part numbers 

OR 

LH - N4597, RH - N4596 - Both of these are EARLIER year part numbers 

Rotor Only - 4885677 - all years